保洁程序标准
Cleaning Procedure Standard
所用工具
Tools used
大型吸尘吸水机、多功能擦地机、玻璃套装工具、加长杆、梯子、水桶、掸子、云石铲刀、刮子、涂水器等。
Large vacuum absorber, multi-functional floor scrubber, glass set tools,
lengthening rod, ladder, bucket, duster, marble spade, scraper, water
applicator, etc.
清洁剂
Cleaning agent
全能清洗剂、玻璃清洗剂、瓷砖清洗剂、陶瓷清洗剂、去胶剂、除渍剂、酸性清洁剂、洁厕剂、不锈钢清洗剂、不锈钢光亮剂、家私蜡等。
All-round cleaner, glass cleaner, ceramic tile cleaner, ceramic cleaner,
degumming agent, stain remover, acid cleaner, toilet cleaner, stainless
steel cleaner, stainless steel brightener, furniture wax, etc.
开荒程序
Land reclamation program
开荒是清洁工程之首，由于建筑工程中常常会遗留下许多垃圾污垢，各种地面石头，墙壁上会遗留下水泥浆块、油漆、玻璃胶、水污、锈迹等，这些都必须在开荒工作中清洗干净，所以它是一项最艰苦、最复杂、最费神的工作，开荒工程的好坏，直接影响到日后保洁工作的质量和档次，所以做好开荒有着相当重要的要求。
Waste reclamation is the first clean project, because construction
projects often leave a lot of garbage dirt, a variety of ground stones,
walls will leave cement slurry, paint, glass glue, water pollution, rust
and jinggaim.75ix.cn jianchajingm.75ix.cn hupo.75ix.cn jiancha.75ix.cn
hulan.75ix.cn huafenchii.75ix.cnso on, which must be cleaned in the work
of waste reclamation, so it is the most arduous, complex and demanding
work, the quality of waste reclamation projects directly affects the
future protection. Cleaning work quality and grade, so do a good job in
opening up wasteland has very important requirements.
1、 首先清理现场留下的装修垃圾；
1. Clean up the decoration garbage left at the scene first.
2、 由上到下全面吸尘；
2. Full vacuum from top to bottom;
3、 擦玻璃：先用毛巾把玻璃框擦拭干净，再用涂水器沾稀释后的玻璃水溶液，均匀的从上到下涂抹玻璃，有顽固的污渍用铲刀清除干净，再重复以上工序后用刮子从上到下刮干净，用干毛巾擦净框上留下的水痕，玻璃上的水痕用机皮擦拭干净。
3. Glass cleaning: first wipe the glass frame with a towel, then dip the
diluted glass water solution with a water applicator, evenly coat the
glass from top to bottom, with a spade to clean the stubborn stains, and
then repeat the above process with a scraper from top to bottom, wipe
the water marks left on the frame with a dry towel, and wipe the water
marks on the glass with machine skin.
4、
卫生间：坚持由上而下的原则，首先认清卫生间顶子的材质，是PVC的或是铝塑板还是涂料的，再根据不同的材质用不同的清洁方法进行清洁；用清洁球或是板刷清洗卫生间的墙壁，着重瓷砖的缝隙，和瓷砖表面上遗留的胶迹、涂料点、水泥渍等；用毛巾清洁卫生间的洁具，用不锈钢清洗液针对各种龙头、管件进行清洁；用洗地机对地面进行最后的清洁，由其是地面的边角；最后，检查无遗漏后，再用干毛巾把水龙头等管件擦拭一遍。
4. Toilet: adhere to the principle of top-down, first of all, recognize
the material of the top of the toilet, whether it is PVC or
aluminium-plastic board or paint, and then clean the walls of the toilet
with different cleaning methods according to different materials; use
cleaning balls or board brushes to clean the walls of the toilet,
focusing on the crevices of ceramic tiles, and the glue, paint spots and
cement stains left on the surface of ceramic tiles; use towels to clean
the toilet. Sanitary wares in the living room are cleaned with
stainless steel cleaning solution for various faucets and pipe fittings;
the floor is cleaned by a floor washer for the last time, which is the
corner of the ground; finally, after checking for no omissions, wipe the
faucet and other pipe fittings with a dry towel.
5、 厨房：程序同上。注意：因厨房里的不锈钢管件比较多，应是清洁重点。
5. Kitchen: Ibid. Note: Because there are many stainless steel pipes in the kitchen, they should be the focus of cleaning.
6、 卧室及大厅：墙壁用掸子做除尘处理，擦拭开关盒等
6. Bedroom and lobby: the walls are dusted with dusters, switchboxes are wiped, etc.
7、 门及框：分清门的材质，用毛巾擦拭，程序也是从上到下，把毛巾叠成方块，从门的顶部开始从左到右的擦拭，不能有遗漏
7. Door and frame: distinguish the material of the door, wipe it with a
towel, the procedure is also from top to bottom, fold the towel into
square, wipe it from the top of the door from left to right, no omission
